Network Working Group M. Brenner
Request for Comments: 5224 Alcatel-Lucent
Category: Informational March 2008
Diameter Policy Processing Application
Status of This Memo
This memo provides information for the Internet community. It does
not specify an Internet standard of any kind. Distribution of this
memo is unlimited.
Abstract
This document describes the need for a new IANA Diameter Command Code
to be used in a vendor-specific new application for invocation of
Policy Processing (Policy Evaluation, or Evaluation and Enforcement).
This application is needed as one of the implementations of the Open
Mobile Alliance (OMA) Policy Evaluation, Enforcement and Management
(PEEM) enabler, namely for the PEM-1 interface used to send a
request/response for Policy Processing.
Table of Contents
1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . 2
2. Terminology . . . . . . . . . . . . . . . . . . . . . . . . . . 2
3. Diameter Policy Processing Application . . . . . . . . . . . . 2
4. Security Considerations . . . . . . . . . . . . . . . . . . . . 2
5. IANA Considerations . . . . . . . . . . . . . . . . . . . . . . 3
5.1. Command Codes . . . . . . . . . . . . . . . . . . . . . . . 3
5.2. AVP Codes . . . . . . . . . . . . . . . . . . . . . . . . . 3
5.3. Application Identifier . . . . . . . . . . . . . . . . . . 3
6. Acknowledgements . . . . . . . . . . . . . . . . . . . . . . . 3
7. References . . . . . . . . . . . . . . . . . . . . . . . . . . 4
7.1. Normative References . . . . . . . . . . . . . . . . . . . 4
7.2. Informative References . . . . . . . . . . . . . . . . . . 4
Brenner Informational [Page 1]RFC 5224 PEEM March 2008
1. Introduction
This document summarizes the use of Diameter codes in a newly defined
realization of a specification for invocation of policy processing.
A new Command Code has been assigned by IANA. The document
summarizes the uses of newly defined Diameter codes (a Command Code,
an AVP, and a vendor-specific application id). When combined with
the Diameter Base protocol, this application's specification
satisfies the Open Mobile Alliance (OMA) Policy Evaluation,
Enforcement, and Management (PEEM) requirements for sending a request
for policy processing and receiving a response with the policy
processing result. See [PEM-1-TS] for the normative use of Diameter.
PEEM requirements are documented in [PEEM-RD] and PEEM Architecture
is documented in [PEEM-AD].
The Diameter realization of this application assumes the use of the
Diameter Base protocol, as per RFC 3588, and extends it only for a
specific application using a vendor-id (PEN), a vendor-specific
application ID, a new Command Code (314), and a new AVP defined in
the vendor-specific namespace. Input to policy processing are being
passed through a new AVP, and policy results are being passed through
a combination of the same new AVP, and the Experimental-Result AVP.
2. Terminology
The base Diameter specification (Section 1.4 of [RFC3588]) defines
most of the terminology used in this document. Additionally, the
terms and acronyms defined in [PEM-1-TS] are used in this document.
3. Diameter Policy Processing Application
A detailed description of the Diameter Policy Processing Application
can be found in Section 5.4.1 of the Policy Evaluation, Enforcement
and Management Callable Interface (PEM-1) Technical Specification
[PEM-1-TS].
4. Security Considerations
This document describes the Diameter Policy Processing Application.
It builds on top of the Diameter Base protocol and the same security
considerations described in RFC 3588 [RFC3588] are applicable to this
document. No further extensions are required beyond the security
mechanisms offered by RFC 3588.
Brenner Informational [Page 2]
RFC 5224 PEEM March 2008
5. IANA Considerations
This section provides guidance to the Internet Assigned Numbers
Authority (IANA) regarding registration of values related to the
Diameter protocol, in accordance with BCP 26 [RFC2434].
This document defines values in the namespaces that have been created
and defined in the Diameter Base [RFC3588]. The IANA Considerations
section of that document details the assignment criteria. Values
assigned in this document, or by future IANA action, must be
coordinated within this shared namespace.
5.1. Command Codes
This specification assigns the value 314 from the Command Code
namespace defined in [RFC3588]. See Section 5.4.1.3.1 of [PEM-1-TS]
to see how the command code is used.
IANA has made the following assignment in the "Authentication,
Authorization, and Accounting (AAA) Parameters" registry, in the sub-
registry "Command Codes".
Code Value Name Reference
-------------- ------------------------------- ---------
314 PDR / PDA [RFC5224]
5.2. AVP Codes
This specification uses the value 1 for the Policy-Data AVP, in the
OMA Vendor-ID (PEN) AVP namespace. See Section 5.4.1.3.3 of
[PEM-1-TS] for the assignment of the namespace in this specification.
5.3. Application Identifier
This specification uses the value 16777243 in the Application
Identifier namespace as registered in IANA for the Policy Processing
Application. See Section 5.4.1.3 of [PEM-1-TS] for more information.
6. Acknowledgements
The author would like to thank Dan Romascanu and Hannes Tschofenig
for their help and support.
Finally, the author would like to thank Alcatel-Lucent, as most of
the effort put into this document was done while he was in their
employ.
Brenner Informational [Page 3]
RFC 5224 PEEM March 2008
7. References
7.1. Normative References
[PEM-1-TS] Open Mobile Alliance, "Policy Evaluation, Enforcement and
Management Callable Interface (PEM-1) Technical
Specification, Draft Version 1.0, available at http://
www.openmobilealliance.org/ftp/Public_documents/ARCH/
Permanent_documents/
OMA-TS-PEEM_PEM1-V1_0-20080325-D.zip", December 2007.
[RFC3588] Calhoun, P., Loughney, J., Guttman, E., Zorn, G., and J.
Arkko, "Diameter Base Protocol", RFC 3588,
September 2003.
7.2. Informative References
[PEEM-AD] Open Mobile Alliance, "Policy Evaluation, Enforcement and
Management Architecture, Draft Version 1.0, available at
http://www.openmobilealliance.org/ftp/Public_documents/
ARCH/Permanent_documents/
OMA-AD-Policy_Evaluation_Enforcement_Management-V1_0_0-
20060625-D.zip", June 2006.
[PEEM-RD] Open Mobile Alliance, "Policy Evaluation, Enforcement and
Management Requirements, Candidate Version 1.0, 12
January 2005, available at http://
www.openmobilealliance.org/ftp/Public_documents/ARCH/
permanent_documents/
OMA-RD-Policy_Evaluation_Enforcement_Management-V1_0-
20050112-C.zip", November 2005.
[RFC2434] Narten, T. and H. Alvestrand, "Guidelines for Writing an
IANA Considerations Section in RFCs", BCP 26, RFC 2434,
October 1998.
Author's Address
Michael Brenner
Alcatel-Lucent
600-700 Mountain Avenue, 2D-148
Murray Hill, NJ 07974-0636
USA
Phone: +1 908-582-8753
EMail: mrbrenner@alcatel-lucent.com
Brenner Informational [Page 4]RFC 5224 PEEM March 2008
Full Copyright Statement
Copyright (C) The IETF Trust (2008).
This document is subject to the rights, licenses and restrictions
contained in BCP 78, and except as set forth therein, the authors
retain all their rights.
This document and the information contained herein are provided on an
"AS IS" basis and THE CONTRIBUTOR, THE ORGANIZATION HE/SHE REPRESENTS
OR IS SPONSORED BY (IF ANY), THE INTERNET SOCIETY, THE IETF TRUST AND
THE INTERNET ENGINEERING TASK FORCE DISCLAIM ALL WARRANTIES, EXPRESS
OR IMPLIED, INCLUDING BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF
THE INFORMATION HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED
WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Intellectual Property
The IETF takes no position regarding the validity or scope of any
Intellectual Property Rights or other rights that might be claimed to
pertain to the implementation or use of the technology described in
this document or the extent to which any license under such rights
might or might not be available; nor does it represent that it has
made any independent effort to identify any such rights. Information
on the procedures with respect to rights in RFC documents can be
found in BCP 78 and BCP 79.
Copies of IPR disclosures made to the IETF Secretariat and any
assurances of licenses to be made available, or the result of an
attempt made to obtain a general license or permission for the use of
such proprietary rights by implementers or users of this
specification can be obtained from the IETF on-line IPR repository at
http://www.ietf.org/ipr.
The IETF invites any interested party to bring to its attention any
copyrights, patents or patent applications, or other proprietary
rights that may cover technology that may be required to implement
this standard. Please address the information to the IETF at
ietf-ipr@ietf.org.
Brenner Informational [Page 5]
