Internet Engineering Task Force (IETF) J. Arkko
Request for Comments: 5871 Ericsson
Updates: 2460 S. Bradner
Category: Standards Track Harvard University
ISSN: 2070-1721 May 2010
IANA Allocation Guidelines for the IPv6 Routing Header
Abstract
This document specifies the IANA guidelines for allocating new values
for the Routing Type field in the IPv6 Routing Header.
Status of This Memo
This is an Internet Standards Track document.
This document is a product of the Internet Engineering Task Force
(IETF). It represents the consensus of the IETF community. It has
received public review and has been approved for publication by the
Internet Engineering Steering Group (IESG). Further information on
Internet Standards is available in Section 2 of RFC 5741.
Information about the current status of this document, any errata,
and how to provide feedback on it may be obtained at
http://www.rfc-editor.org/info/rfc5871.
Copyright Notice
Copyright (c) 2010 IETF Trust and the persons identified as the
document authors. All rights reserved.
This document is subject to BCP 78 and the IETF Trust's Legal
Provisions Relating to IETF Documents
(http://trustee.ietf.org/license-info) in effect on the date of
publication of this document. Please review these documents
carefully, as they describe your rights and restrictions with respect
to this document. Code Components extracted from this document must
include Simplified BSD License text as described in Section 4.e of
the Trust Legal Provisions and are provided without warranty as
described in the Simplified BSD License.
Arkko & Bradner Standards Track [Page 1]RFC 5871 IPv6 RH IANA Rules May 2010
1. Introduction
This document specifies the IANA guidelines [RFC5226] for allocating
new values for the Routing Type field in the IPv6 Routing Header
[RFC2460]. Previously, no IANA guidance existed for such
allocations.
2. IANA Considerations
New Routing Type values are allocated through IETF Review or IESG
Approval [RFC5226].
Note that two experimental values (253 and 254) are already available
for use [RFC4727].
3. Security Considerations
This specification does not change the security properties of the
Routing Header. However, past experience shows that it is easy to
design routing headers that have significant problems [RFC5095].
4. References
4.1. Normative References
[RFC2460] Deering, S. and R. Hinden, "Internet Protocol, Version 6
(IPv6) Specification", RFC 2460, December 1998.
[RFC5226] Narten, T. and H. Alvestrand, "Guidelines for Writing an
IANA Considerations Section in RFCs", BCP 26, RFC 5226,
May 2008.
4.2. Informative References
[RFC4727] Fenner, B., "Experimental Values In IPv4, IPv6, ICMPv4,
ICMPv6, UDP, and TCP Headers", RFC 4727, November 2006.
[RFC5095] Abley, J., Savola, P., and G. Neville-Neil, "Deprecation
of Type 0 Routing Headers in IPv6", RFC 5095,
December 2007.
Arkko & Bradner Standards Track [Page 2]RFC 5871 IPv6 RH IANA Rules May 2010
Appendix A. Changes from RFC 2460
This document specifies only the IANA rules associated with the
Routing Type field.
Authors' Addresses
Jari Arkko
Ericsson
Jorvas 02420
Finland
EMail: jari.arkko@piuha.net
Scott Bradner
Harvard University
Cambridge, MA 02138
US
Phone: +1 617 495 3864
EMail: sob@harvard.edu
Arkko & Bradner Standards Track [Page 3]
